If you want to prepare Cisco Certified Network Professional Routing and Switching 300-115 exam in short time then you can get latest Cisco 300-115 Practice Test Software similar to actual 300-115 exam. Practicetestguru provides you Cisco 300-115 dumps in two formats. You can prepare well through 300-115 PDF Q&A booklet and 300-115 exam practice test software with confidence to succeed by saving your time and money both.

Vendor Cisco
Exam Code 300-115
Full Exam Name Implementing Cisco IP Switched Networks
Certification Name Cisco Certified Network Professional Routing and Switching
Technology Network Security

♥ 2019 Valid 300-115 Exam Questions ♥

300-115 exam questions, 300-115 PDF dumps; 300-115 exam dumps:300-115 Dumps (570 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-115 Exam Questions:

Version: 35.0

Question: 1

Which two VLAN ranges can you add. modify or delete on a switch’? (Choose two)

  1. 1 through 1001
  2. 1006 through 4094
  3. 1005 through 4094
  4. 2 through 1001
  5. 2 through 4094

Answer: BD

Question: 2

Which Cisco technology provides network redundancy by combining two physically separate

switches to a single logical switch’?

  1. VSS
  2. IPPS
  3. PAGP
  4. LACP

Answer: A

Question: 3

Which two commands configure RSPAN to capture incoming and outgoing traffic on a single

interface’? (Choose two)

  1. monitor session 1 source interface gigabitethernetl/0/2 tx
  2. monitor session 1 destination remote vlan 910
  3. monitor session 1 source interface gigabitethernetl/0/1 rx
  4. monitor session 1 destination interface gigabitethernetl/0/2 rx
  5. monitor session 1 source interface gigabitethernet1/0/2 both

Answer: BE

Question: 4

Which feature is enabled automatically when you configure HSRP on an interface?

  1. ICMP redirect messages
  2. HSRP tracking
  3. IGMP snooping
  4. HSRP preemption

Answer: A

Question: 5

Which command do you enter to troubleshoot a misconfigured EtherChannel?

  1. CORE-SW(config)#spanning-tree etherchannel guard misconfig.
  2. CORE-SW(config-if)#spanning-tree guard root
  3. CORE-SW(config-if)#spanning-tree loopguard default
  4. CORE-SW(config-if)#spanning-tree etherchannel guard misconfig

Answer: A

Question: 6

Which statement about configuring an RSPAN session is true?

  1. RSPAN supports, by default, the monitoring of Layer 2 switch protocols.
  2. The same RSPAN VLAN is used for a RSPAN session on all the switches.
  3. Only the source switch in a session must support RSPAN
  4. At least one access port must be configured in the RSPAN VLAN

Answer: B

New Updated 300-115 Exam Questions 300-115 PDF dumps 300-115 practice exam dumps:https://www.dumpsschool.com/300-115-exam-dumps.html

         

Facebook Comments