Latest Juniper JN0-661 Exam Questions – [Feb-2018 Dumps]

Juniper Service Provider Routing and Switching JN0-661 exam Route summarization and route leaking Policers, including tricolor marking and hierarchical policers and Given a scenario, demonstrate knowledge of how to configure and monitor IGMP, PIM-DM, PIM-SM (including SSM) and MSDP. If you want to prepare JN0-661 exam in short time then you can get latest Service Provider Routing and Switching JN0-661 exam questions similar to actual JN0-661 exam. Practicetestguru provide you JN0-661 dumps in two formats. You can prepare well through PDF Q&A booklet and JN0-661 exam practice test software with confidence to succeed by saving your time and money both.

♥ VALID JN0-661 Exam Questions 2018 ♥

JN0-661 exam questions, JN0-661 PDF dumps; JN0-661 exam dumps:: https://www.dumpsschool.com/JN0-661-exam-dumps.html (133 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Juniper JN0-661 Dumps Exam Questions and Answers:

Version: 8.0
Question: 21

A new service provider asked you to design its IS-IS network. You determined that two distinct IS-IS areas will be required and you must now create an ISO addressing plan for the participating intermediate systems (routers)
In this scenario, which two statements are correct? (Choose two.)

A. The NET addresses can be configured on any interface.
B. The NET addresses must be configured on the loopback interface
C. The system ID within the NET address must match for all intermediate systems within the same area.
D. The system ID within the NET address must unique for all intermediate systems within the same area.

Answer: A, D

Question: 22

What are two characteristics of L3VPNs? (Choose two )

A. Matching route targets are required for L3VPNs to function correctly.
B. Multiprotocol BGP is required for L3VPNs to function correctly.
C. The IPv4 NLRI is required for L3 VPNs to function correctly.
D. Matching route distinguishes are required for L3VPNs to function correctly

Answer: A, D

Question: 23

Referring to the exhibit, you have configured an L3VPN that connects Site-1 and Site-2 together, but the BGP routes are being hidden on the PE routers. The topology in this scenario is shown below.
Site-1 > PE-1 > P-1 > P-2 > PE-2 > Site-2
Which two acttions would allow communication Site-1 and Site-2? (Choose two.)

A. Disable CSPF on under MPLS on P-1 and P-2.
B. Configure DGP on P-1 and P-2.
C. Enable RSVP for all interfaces on P-1 and P-2.
D. Enable LDP for all interfaces on all routers.

Answer: C, D

Question: 24

A layer 2 circuit (RFC 4447) is established between two PE routers to provide connectivity between two customer sites. Which two statements related to this deployment are true?

A. Kompella encapsulation is used in the data plane communications.
B. LDP must be used for the control plane communications
C. BGP must be used for the control plane communications.
D. Martini encapsulation is used in the data plane communications.

Answer: B, D

Question: 25

Referring to the exhibit, which router will be the RP?

A. R4 for all groups
B. R1 for group 224.1.1.11 and R4 for all other groups
C. R1 for all groups
D. R4 for group 224.1.1.12 and R1 for all other groups

Answer: A

Question: 26

You must ensure that r1’s IPv4 loopback address exists in r3’s inet 0 routing table
Referring to the exhibit, which statement is true?

A. An IPv4 unicast realm can be enabled on each router.
B. A policy can be configured on M to redistribute 172.16.100.1/32 into OSPFv2, which would cause r3 to eventually learn the route and place it into inet0.
C. A RIB group can be configured on r3 to copy that route into inet 0 because 172.16.100.1/32 exists in r3’s inet6.0 table
D. A policy can be configured on r1 to redistribute 172 16 100 1/32 into OSPFv3, which would cause r3 to eventually learn the route and place it into inet 0.

Answer: C

New Updated JN0-661 Exam Questions JN0-661 PDF dumps JN0-661 practice exam dumps: https://www.dumpsschool.com/JN0-661-exam-dumps.html